Post by Stefan on Jul 20, 2024 10:17:41 GMT -5
George,
Sorry, I'm in a macro-writing mood and just tripped over this.
It's an issue with the official v3 release but not with v2 last beta v3.02.24091.
Scenario: You have IMACRO XXXX ON specified in the profile, and macro XXXX issues a HALT(FAIL,"some message") statement
In version v3.02.24091, regardless of a FAIL or OK return code, the message appears immediately after the file was loaded.
Any subsequent RELOAD command produces the same result.
In the current v3 Release version, regardless of the FAIL or OK return code, the message flashes up briefly but does not remain on the screen.
Worse still, if you think "what was that I just missed?" and issue a RELOAD command, the macro goes into a loop usually resulting in SPFLite Termination.
This loop does not occur if the HALT statement specifies OK or nothing.
This simple macro whould demonstrate - just set it as IMACRO for your test profile
000001 ' XXXX.Macro
000002 SPF_Debug("IMACRO-------------")
000003 ' Halt(FAIL,"Fail message - flashes up and RELOAD cmd results in loop/crash")
000004 Halt(OK,"OK message - flashes up but no loop when RELOAD is used")
